...

• Lift the machine from below the base plate and place it in its intended operating position.

• Remove the protective plastic film from the machine.

• Using a 4mm Allen key, unscrew and remove the shipping braces on the X, Y and Z ball-screws (5 pieces in total).

  

• Locate a suitable electrical outlet and ensure the main power switch of the HS3 is in the OFF position. Plug the machine into mains power using the provided power cable.

• Flip the main power switch to the ON position. The switch should illuminate. The servo motors of the machine will energize and an audible “clunk” may be heard. This is not a concern.

• The machine’s display will become active and will go through several start up screens. The machine’s touchscreen is ready to interact with when you are presented with the following display:

...

Connecting to a Network

Wi-Fi

• On the front panel of the printer navigate to the Utilities sub menu and then Network.The machine will search for available networks. If none are present, tap the refresh button.

...