Page Comparison

Video Guides

https://www.youtube.com/watch?v=Trlyus1EXAI&ab_channel=PantheonDesign

https://www.youtube.com/watch?v=NOxpdNw91YA&ab_channel=PantheonDesign

Tools

• Flush Cutters

• 2mm, 2.5mm Hex Drivers

• Loctite 243

• Torque Screwdriver (0.9Nm7Nm)

• Cable Tie

Step 1: Unload Filament and Remove Print Head

To begin, follow the existing guides on our wiki for to remove the unloading the printhead of filament and removing the printhead from your machine. before starting this full guide:

https://pantheondesign.atlassian.net/wiki/spaces/DSBM/pages/673710240/Material+Handling#Unloading-Printhead

https://pantheondesign.atlassian.net/wiki/spaces/DSBM/pages/676036609/Install+and+Remove+A+Printhead#Removing-A-Printhead

Once the printhead is removed, bring it to a workbench to facilitate the replacement process.

Step 2: Cut Zip Ties

Inspect your printhead for a zip tie on the part cooling duct. If your printhead is a newer model with a zip tie, cut it to release the Hotend cables. Older printheads may not have this feature, in which case you can skip this step.

Image Removed

Image Added

Step 3: Disconnect Heater and Thermistor Cartridge Plugs

Disconnect all heater cartridge plugs and the thermistor cartridge plug from the PCB.

Image Removed

Image Added

Step 4: Disconnect the Part Cooling Fan

Unscrew the part cooling fan duct (2.5mm Hex) and remove the part cooling fan plug connected to the PCB.

Image Removed

Image Removed

Image Added

Image Added

Step 5: Remove the Old Hotend

Using a screwdriver, remove the two socket head screws on the heat block (2mm Hex). Once the screws are loosened, the Hotend should be able to wiggle free from the printhead.

Image Removed

Image Added

Step 6: Install the New Hotend

Ensure that your new Hotend has the four heat break tubes installed, as well as the socket head screws. Apply a small amount of Loctite 243 on the socket head screws and insert them into the printhead. Gradually torque the screws to a value of 0.9 7 Nm going back and forth between the two screws to apply even pressure.

Step 7: Reattach the Part Cooling Fan

Install the part cooling fan (2.5mm Hex) hand tight and reconnect the fan cable.

Step 8: Reconnect the Thermistor and Heater Cartridge Plugs

Insert the thermistor plug and the heater cartridge plugs into their respective connections on the PCB.

Image Removed

Image Added

Step 9: Secure Hotend Cables

If your part cooling fan duct has a cable tie pointpoints, use a zip tie ties to secure the Hotend cables in place.