This quick-start guide briefly covers the installation and operation of the Pantheon HS3 Additive Manufacturing System. More detailed information regarding the topics of this guide can be found in the rest of this user portal.
It is recommended to perform all the installation steps at the machine. Do not perform operations from the web console that result in motion of the printer unless directly present, i.e. sitting in front of it with a computer. |
|
Allow yourself ample space to unbox and install the machine.
The machine alone weighs approximately 65 kg (143lbs) and thus requires two people to lift or move.
The machine should be operated indoors within the nominal temperature range of 10-35℃.
The machine should be placed on a rigid and level surface. You need a sturdy table, a cheap IKEA table will break and drop the printer on the floor!
The recommended space requirements for the machine are 100 cm by 70 cm with at least 120 cm height to allow for the enclosure lid to open. If placed on a table or work surface, the surface should be able to support 65 kg. See Table Options for HS3 for an idea of what we recommend.
The machine is powered from a standard 120VAC 15A wall outlet.
A strong and secured wireless network or ethernet connection is required.
|
Using a hammer to bend back the tabs at the edges and bottom of the crate.
PXL_20230724_023223831.LOCKED.TS.mp4~3.mp4Remove the Lid of the crate first, then the side panels.
Remove the tape securing the door and lid of the machine.
Remove the protective plastic film from the machine
Using a 1/4” socket, or an empty multi-bit screwdriver, remove the brackets securing the machine feet to the crate base (4 pieces in total).
Inspect for any damage that may have occurred during shipping.
|
Lift the machine from below the base plate and place it in its intended operating position.
Using a 4mm Allen key, unscrew and remove the shipping braces on the X, Y and Z ballscrews (5 pieces in total).
Locate a suitable electrical outlet and ensure the power switch on HS3 is in the OFF position. Plug the machine into mains power using the provided electrical cable.
Flip the power switch of HS3 to the ON position. The switch should illuminate. The servo motors of the machine will energize and an audible “clunk” may be heard. This is not a concern.
On the front panel of the printer press the settings button on the touch panel, then select the network button. See How to use the HS3's touchscreen.
The Wi-Fi screen currently may take a long time to load. If after 5 minutes no networks appear, reboot the machine and try again. If the problem persists, contact support: support@pantheondesign.ca |
Select your network and enter the password
plug your ethernet cable into the ethernet jack on the back of the HS3, its located above the power cord receptacle
It may take 1-2 minutes for the ethernet to connect
Please connect to the web interface to validate that the network connection is active
On the printers touchscreen click the settings button then the network button
On the top left of the screen, it will display the local address, it will start with 192.
Type the IP address in a web browser connected on the same internet network as the printer and the web interface will load
If you’re unable to access the web interface, contact support: support@pantheondesign.ca |
Using the touchscreen on the machine, navigate to the homing page and press home all.
Navigate to the move panel on the screen and move the Z axis down by pressing the Z- button. Move the axis to Z=250.
Install the smooth or textured bed. Be sure to remove any protective film from the smooth bed. Align with the two pins at the back of the heated plate.
See the Load and Unload Filament instructions to install filament.
Once filament is loaded, see the Running A Print On The HS3 instructions.