Install and Remove an HS-Pro Printhead
Installing A Printhead
NOTICE Make sure the printer is turned off and unplugged before starting the procedure. Ensure the filament is also removed.
Tools and Parts Required
3mm Allen Hex Driver
Procedure
To install the printhead, support it and align it will the pins.
Slide the printhead onto the pins while holding the printhead in place. Ensure the printhead is fully seated on the pins before tightening the screws.
Tighten the two screws that secure the printhead.
Plug the primary electrical connector in.
Close the printer lid.
Turn on the printer and test the printhead to ensure it is functioning properly.
Removing A Printhead
notice Make sure the printer is turned off with the bed at the bottom and unplugged before starting the procedure. Ensure the filament is also removed.
Tools and Parts Required:
3mm Allen Hex Driver
Procedure
Lift the lid of the printer to gain access to the printhead.
Unplug the primary electrical connector.
The printhead is held in place with two M4 screws located near the top of the printhead.
Loosen these two screws while supporting the printhead. It is held in alignment with two small pins but may fall downward if not supported when loosening the screws.
Once the two screws are fully loosened, wiggle the printhead to free it from the pins.
The print head is now completely removed and can be set off to the side.