Updating Slicer Settings - PantheonSlicer

Owned by Alex Wiecke
Aug 14, 2023
2 min read

PantheonSlicer checks for settings updates when it starts.

If an update is available, a card will pop up in the corner showing that an update is available:

Click See more and a window will describe the update, press “OK” and it will be installed:

Sometimes, filaments may not appear as expected after the update, and a placeholder “- default -” filament is shown instead:

In this case, open the Configuration wizard under Configuration->Configuration Wizard:

Click to the “Filaments” step, make sure all filaments are checked in the right panel, then press “Finish”:

 

www.pantheondesign.com