Page Comparison

...

• Allow yourself ample space to unbox and install the machine.

• The machine alone weighs approximately 65 kg (143lbs) and thus requires two people to lift or move.

• The machine should be operated indoors within the nominal temperature range of 10-35℃.

• The machine should be placed on a rigid and level surface. You need a sturdy table, a cheap IKEA table will break and drop the printer on the floor!

• The recommended space requirements for the machine are 100 cm by 70 cm with at least 120 cm height to allow for the enclosure lid to open. If placed on a table or work surface, the surface should be able to support 65 kg.

• The machine is powered from a standard 120VAC 15A wall outlet.

• A strong and secured wireless network or ethernet connection is required.

...

• Open the shipping box with , using a flathead screwdriver hammer to bend back the tabs at the edges and bottom of the crate.
  

  PXL_20230724_023223831.LOCKED.TS.mp4~3.mp4

• Remove the tape securing the door and lid of the machine.

• Remove the protective plastic film from the machine

• Remove the shipping straps Using a 1/4” socket, or an empty multi-bit screwdriver, remove the brackets securing the machine feet to the crate base

• Remove the Wooden braces surrounding the machine base

• Remove the tape securing the contents of the machine work area and remove them from the machine.(4 pieces in total).
  

  Image Added

• Inspect for any damage that may have occurred during shipping.

...

• Lift the machine from below the base plate and place it in its intended operating position.

• Open the enclosure lid and using wire cutters completely remove the zip ties securing Using a 4mm Allen key, unscrew and remove the shipping braces on the X, Y , and Z axes.ballscrews (5 pieces in total).
  

  Image Added

• Locate a suitable electrical outlet and ensure the power switch on HS3 is in the OFF position. Plug the machine into mains power using the provided electrical cable.

• Flip the power switch of HS3 to the ON position. The switch should illuminate. The servo motors of the machine will energize and an audible “clunk” may be heard. This is not a concern.

Connecting to your network

...

WiFi

• On the front panel of the printer press the settings button on the touch panel, then select the network buttonselect . See How to use the HS3's touchscreen.

• Select your network and enter the password

...

• plug your ethernet cable into the ethernet jack on the back of the HS3, its located above the power cord receptacle

• it It may take 1-2 minutes for the ethernet to connect

Connecting to the web interface

please Please connect to the web interface to validate that the network connection is active

• On the printers touchscreen click the settings button then the network button

• on On the top left of the screen, it will display the local address, it will start with 192.

• Type the IP address in a web browser connected on the same internet network as the printer and the web interface will load

• See How To Use The HS3's Web Interface.