Installing A Printhead

Tools and Parts Required:

• 3mm Allen Hex Driver

• Four M4x10mm Socket Head Bolts

Procedure

• To install the printhead, hold the printhead close to the electrical connector and plug it in securely.

• Slide the printhead onto the pins while holding the printhead in place.

• Loosely insert one of the M4x10mm socket head bolts and tighten it with the 3mm Allen wrench.

• Once the printhead is held in place by the one bolt, install the other three.

• Tighten all four bolts securely with an M3 Allen wrench.

• Close the printer lid.

• Turn on the printer and test the printhead to ensure it is functioning properly.

Removing A Printhead

Tools and Parts Required:

• 3mm Allen Hex Driver

• Four M4x10mm Socket Head Bolts

Procedure

• Lift the lid of the printer to gain access to the printhead.

• Manually bring the printhead closer to you and locate the four bolts on the back of the printhead.

• The printhead rests on two alignment pins and is fastened to the X-axis using four M4x10mm socket head bolts. Use the 3mm Allen wrench to loosen and remove the four bolts. Be sure to keep the bolts in a safe place as they will be needed later.

• After removing the bolts, the printhead is only resting on the two alignment pins, be careful not to drop the printhead. It is advised to always have a hand on the printhead.

• Lift the printhead off of the pins while also disconnecting the electrical connector.

• The print head is now completely removed and can be set off to the side.