Printhead is not

Extruding

Nozzle Jam

Replace a Nozzle

Hotend Jam

How to Replace a Hot End

Extruder Jam

Clearing a Printhead Drive Roller Jam

Extruder Driveshaft Failure

Motion system is noisy

Dirty or no lubricant

Lubricate The Motion System

Clicking or squeaking noise from X or Y axis

Bearing

Failure

Replacing a Y-Motor Mount

Coupler Failure

Y-axis Servo Motor Couplers

Thermocouple Reader Fault

Temperature Sensor Fault

https://pantheondesign.atlassian.net/wiki/spaces/DSBM/pages/675381665/Error+and+Warning+Messages#Thermocouple-Reader-Fault

Heater not Heating at Expected Rate

Temperature Sensor Fault

https://pantheondesign.atlassian.net/wiki/spaces/DSBM/pages/675381665/Error+and+Warning+Messages#Heater-not-Heating-at-Expected-Rate

Heating Element Fault

https://pantheondesign.atlassian.net/wiki/spaces/DSBM/pages/675381665/Error+and+Warning+Messages#Heater-not-Heating-at-Expected-Rate

ADC out of Range

Temperature Sensor Fault

https://pantheondesign.atlassian.net/wiki/spaces/DSBM/pages/675381665/Error+and+Warning+Messages#ADC-out-of-Range

MCU Unable to Connect

Unplugged Printhead

https://pantheondesign.atlassian.net/wiki/spaces/DSBM/pages/675381665/Error+and+Warning+Messages#MCU-Unable-to-Connect

Blown Printhead Fuse

https://pantheondesign.atlassian.net/wiki/spaces/DSBM/pages/675381665/Error+and+Warning+Messages#MCU-Unable-to-Connect