...
| Panel | ||||||
|---|---|---|---|---|---|---|
| ||||||
|
| Status | ||||
|---|---|---|---|---|
|
Index
| Table of Contents | ||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
...
Symptom | Possible Cause | Solution |
|---|---|---|
First layer is squished | Wet Filament Debris on bed during probing Bed is not level | |
Debris on bed during probing | ||
Bed is not level | https://pantheondesign.atlassian.net/wiki/spaces/DSBM/pages/675840160/Heated+Bed#Calibration | |
Z-banding | Ball screw wobble | |
Damaged Z-axis Ball-screw(s) | ||
First few layers of the print look “crunchy”, but subsequent prints do not | Filament has become wet in the filament tube |
...
Printer Malfunction or Abnormality
Symptom | Possible Cause | Solution |
|---|---|---|
Printhead is not Extruding | Nozzle Jam | |
Hotend Jam | ||
Extruder Jam | ||
Extruder Driveshaft Failure | ||
Motion system is noisy | Dirty or no lubricant | |
Clicking or squeaking noise from X or Y axis | Bearing Failure | |
Coupler Failure |
...
Error and Warning Messages
Message | Possible Cause | Solution |
|---|---|---|
Thermocouple Reader Fault | Temperature Sensor Fault | |
Heater not Heating at Expected Rate | Temperature Sensor Fault | |
Heating Element Fault | ||
ADC out of Range | Temperature Sensor Fault | |
MCU Unable to Connect | Unplugged Printhead | |
Blown Printhead Fuse |
...