This page is incomplete
| Panel | ||||||
|---|---|---|---|---|---|---|
| ||||||
|
| Status | ||||
|---|---|---|---|---|
|
Index
...
Symptom | Possible Cause | Solution |
|---|---|---|
First layer is squished | Wet Filament Debris on bed during probingBed is not level | |
Debris on bed during probing | ||
Bed is not level | https://pantheondesign.atlassian.net/wiki/spaces/DSBM/pages/675840160/Heated+Bed#Calibration | |
Z-banding | Ball screw wobble | |
Damaged Z-axis Ball-screw(s) | Z-Motor and Ball-Screw Assembly Ball Screw Linear Wobble | |
First few layers of the print look “crunchy”, but subsequent prints do not | Filament has become wet in the filament tube |
...
Printer Malfunction or Abnormality
Symptom | Possible Cause | Solution | |
|---|---|---|---|
Printhead is not | Extruding | Nozzle Jam Hotend Jam Extruder Jam | |
Hotend Jam | |||
Extruder Jam | |||
Extruder Driveshaft Failure | |||
Motion system is noisy | Dirty or no lubricant | ||
Clicking or squeaking noise from X or Y axis | Bearing FailureCouplerFailure | ||
Coupler Failure |
...
Error and Warning Messages
Message | Possible Cause | Solution |
|---|---|---|
Thermocouple Reader Fault | Temperature Sensor Fault | |
Heater not Heating at Expected Rate | Temperature Sensor Fault | |
Heating Element Fault | ||
ADC out of Range | Temperature Sensor Fault | |
MCU Unable to Connect | Unplugged Printhead | |
Blown Printhead Fuse |
...