First layer is squished

Wet Filament

https://pantheondesign.atlassian.net/wiki/spaces/DSBM/pages/673710240/Material+Handling#Filament-Moisture

Debris on bed during probing

https://pantheondesign.atlassian.net/wiki/spaces/DSBM/pages/673939985/Normal+Operations#Preparing-the-Printer-and-Starting-a-Print

Bed is not level

https://pantheondesign.atlassian.net/wiki/spaces/DSBM/pages/675840160/Heated+Bed#Calibration

Z-banding

Ball screw wobble

Ball Screw Linear Wobble

Damaged Z-axis Ball-screw(s)

Z-Motor and Ball-Screw Assembly

First few layers of the print look “crunchy”, but subsequent prints do not

Filament has become wet in the filament tube

https://pantheondesign.atlassian.net/wiki/pages/resumedraft.action?draftId=685867034&draftShareId=d5eb5b8f-4e8d-4ecb-8d58-f210dd81fc74

Printhead is not

Extruding

Nozzle Jam

Replace a Nozzle

Hotend Jam

How to Replace a Hot End

Extruder Jam

Clearing a Printhead Drive Roller Jam

Extruder Driveshaft Failure

Motion system is noisy

Dirty or no lubricant

Lubricate The Motion System

Clicking or squeaking noise from X or Y axis

Bearing Failure

Replacing a Y-Motor Mount

Coupler Failure

Y-axis Servo Motor Couplers

Thermocouple Reader Fault

Temperature Sensor Fault

https://pantheondesign.atlassian.net/wiki/spaces/DSBM/pages/675381665/Error+and+Warning+Messages#Thermocouple-Reader-Fault

Heater not Heating at Expected Rate

Temperature Sensor Fault

https://pantheondesign.atlassian.net/wiki/spaces/DSBM/pages/675381665/Error+and+Warning+Messages#Heater-not-Heating-at-Expected-Rate

Heating Element Fault

https://pantheondesign.atlassian.net/wiki/spaces/DSBM/pages/675381665/Error+and+Warning+Messages#Heater-not-Heating-at-Expected-Rate

ADC out of Range

Temperature Sensor Fault

https://pantheondesign.atlassian.net/wiki/spaces/DSBM/pages/675381665/Error+and+Warning+Messages#ADC-out-of-Range

MCU Unable to Connect

Unplugged Printhead

https://pantheondesign.atlassian.net/wiki/spaces/DSBM/pages/675381665/Error+and+Warning+Messages#MCU-Unable-to-Connect

Blown Printhead Fuse

https://pantheondesign.atlassian.net/wiki/spaces/DSBM/pages/675381665/Error+and+Warning+Messages#MCU-Unable-to-Connect