Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Version History

« Previous Version 4 Next »

This page is incomplete

Index

Print Quality Issues

Print quality issues are telltale signs of a component or system of the HS3 underperforming. Use this guide to help determine the root cause of the print quality issue.

Symptom

Possible Cause

Solution

First layer is squished

  • Wet Filament

  • Debris on bed during probing

  • Bed is not level

Printer Malfunction or Abnormality

Symptom

Possible Cause

Solution

Printhead is not extruding

  • Nozzle Jam

  • Hotend Jam

  • Extruder Jam

  • Extruder Driveshaft Failure

Motion system is noisy

  • Dirty or no lubricant

Clicking or squeaking noise from X or Y axis

  • Bearing Failure

  • Coupler Failure

Error and Warning Messages

Message

Possible Cause

Solution

Thermocouple Reader Fault

  • Temperature Sensor Fault

https://pantheondesign.atlassian.net/wiki/spaces/DSBM/pages/675381665/Error+and+Warning+Messages#Thermocouple-Reader-Fault

Heater not Heating at Expected Rate

  • Temperature Sensor Fault

  • Heating Element Fault

https://pantheondesign.atlassian.net/wiki/spaces/DSBM/pages/675381665/Error+and+Warning+Messages#Heater-not-Heating-at-Expected-Rate

ADC out of Range

  • Temperature Sensor Fault

https://pantheondesign.atlassian.net/wiki/spaces/DSBM/pages/675381665/Error+and+Warning+Messages#ADC-out-of-Range

MCU Unable to Connect

  • Unplugged Printhead

  • Blown Printhead Fuse

https://pantheondesign.atlassian.net/wiki/spaces/DSBM/pages/675381665/Error+and+Warning+Messages#MCU-Unable-to-Connect

  • No labels

www.pantheondesign.com