NOTICE Many of the solutions in this troubleshooting guide involve replacing hardware that is unavailable on on web store, if so, please contact support@pantheondesign.ca to purchase parts or submit warranty claims.
TIP This troubleshooting guide is an ever-expanding document to help you solve problems that may occur.
Index
Print Quality Issues
Print quality issues are telltale signs of a component or system of the HS3 underperforming. Use this guide to help determine the root cause of the print quality issue.
Symptom | Possible Cause | Solution |
|---|---|---|
First layer is squished | Wet Filament | |
Debris on bed during probing | ||
Bed is not level | https://pantheondesign.atlassian.net/wiki/spaces/DSBM/pages/675840160/Heated+Bed#Calibration | |
Z-banding | Ball screw wobble | |
Damaged Z-axis Ball-screw(s) |
Printer Malfunction or Abnormality
Symptom | Possible Cause | Solution |
|---|---|---|
Printhead is not Extruding | Nozzle Jam | |
Hotend Jam | ||
Extruder Jam | ||
Extruder Driveshaft Failure | ||
Motion system is noisy | Dirty or no lubricant | |
Clicking or squeaking noise from X or Y axis | Bearing Failure | |
Coupler Failure |
Error and Warning Messages
Message | Possible Cause | Solution |
|---|---|---|
Thermocouple Reader Fault | Temperature Sensor Fault | |
Heater not Heating at Expected Rate | Temperature Sensor Fault | |
Heating Element Fault | ||
ADC out of Range | Temperature Sensor Fault | |
MCU Unable to Connect | Unplugged Printhead | |
Blown Printhead Fuse |