Pantheon Filaments
- Bobc
- CaseyHWong
This article is a general usage guide for Pantheon materials
Basic Material Data
| CF-PETG | CF-Nylon | GF-Nylon |
|---|---|---|---|
Tensile Strength ISO 527 | 49 MPa | 119 MPa | 89 MPa |
Young's Modulus ISO 527 | 4200 MPa | 8150 MPa | 4955 MPa |
Heat Deflection @ 0.45MPa | 72 °C | 186 °C | 170 °C |
Heat Deflection @ 1.80MPa | N/A | 112 °C | 111 °C |
Filament Handling
Most plastics absorb moisture from the air, and hydration causes many issues during printing.
When handling Pantheon filament, be especially careful with exposing it to air.
Opening a spool
When opening a spool, try to move it immediately into a spool holder. Don't leave it on the counter while you grab a coffee, etc.
Spool holder
on the spool holder, make sure:
The humidity is at 10% or lower, if higher, refill with dry desiccant
when you open the spool holder, it will spike up but should settle back within half an hour
the latch is always closed, this preloads the foam seal
Swapping spools
When swapping a partially used spool, make sure you store the partial spool in a sealed container with desiccant.
a ziplock back with no desicant is not a acceptable storage solution, water molecules are tiny, so tiny infact that they can work their way through the plastic of the bag.
We recommend a Tupperware container with a silicone seal and a handful of desiccant at the bottom.
Filament Selection
We have 3 materials to select from; we generally use CF-PETG for most prints; it's got a great combination of feature detail, print speed, strength, and environmental resistance.
The Nylons we have are in general, higher temperature and stronger for the trade of off, slower to print, and have less feature detail.
Material selection flow chart
www.pantheondesign.com