How To Install Beta Print Profile

Step 1

Open

Navigate to help and click on Show Configuration Folder

Step 2

Open

Navigate to user>default, you should see the folders filament, machine, and process

Step 3

Open

Transfer the downloaded zip files to your configuration folder by their respective folders. For example, move the contents of zip folder filament to the configuration folder filament and repeat for machine and process.

Open

Step 4

Open

Restart the slicer to see your newly imported profiles. You may need to select the drop downs to find them.

PA-CF 0.125mm

Download ↓

Open

Caveats

Depending on part geometry, the extrusion multiplier and cooling values need to be adjusted to achieve optimal strength and quality.

Perimeter counts of less than 5 require slightly less extrusion. Parts with more perimeters than 8 require significantly less extrusion multiplier, especially when running 100% infill.

As the part increases in surface area for each layer, the thermal mass and heat retention rises and more cooling is required to maintain good overhang performance. When the part is very thin and low mass, it sheds heat very easily and it is important to run minimal cooling to maintain layer bond strength.

For extrusion multiplier it will be flow as shown here:

For cooling it will found here:

Set both min and max values to the same value to keep things simple.